Vikylin RTSP Setup Guide
Connect your Vikylin security cameras to local monitoring software or web dashboards using verified RTSP and CGI snapshot endpoints.
Interactive Connection Generator
Fill in your camera credentials and local IP address below to immediately construct your ready-to-use stream paths.
Main High-Definition Stream (Primary)
rtsp://[USER]:[PASS]@[IP]:554/media/live/1/1
Sub Stream (Low-bandwidth grid view)
rtsp://[USER]:[PASS]@[IP]:554/media/live/1/2
Security Note: Default: admin / 123456.
Step-by-Step Local Configuration
1
Locate Camera IP
Use the Vikylin search tool or your router's client list to find the camera's local IP address.
2
Enable ONVIF/RTSP
Log in to the web interface (default admin/123456) and ensure RTSP is enabled in the Network settings.
3
Configure Stream Resolution
Under Video settings, adjust the bit-rate and frame rate for stream 1 (High-Res) and stream 2 (Low-Res).
Frequently Asked Questions
Q: What is the default password for Vikylin?
Most Vikylin cameras ship with the default password '123456' for the 'admin' user.
Tested Models
The following models have been verified to support standard local RTSP streams natively:
PG-N SeriesV-Series BulletVikylin DomeVikylin PTZ
Quick Optimization Tips
- •Use `/media/live/1/1` for the primary 4K/5MP stream.
- •Snapshot URLs are available via `/cgi-bin/snapshot.cgi?act=snapshot&stream=0`.
- •Vikylin cameras often support standard Hikvision or Dahua protocols depending on the firmware.